BIRD ANY CHIP IR 3000 BGA REWORK STATION BIRD "Better Infrared Device" Environmental requirements of operation and conservation: ★. (1) Operation environment of products ● Operation temperature: 15 ~ 35 C ● Operation humidity: 5% to 95%, non-condensing ● Products should be kept in the air mobility of a smaller environment under the welding operation. ★. (2) Conservation environment of products ● Storage temperature: -20 ~ 35 C ● Storage humidity: 5% to 95%, non-condensing Technical Parameters: 
Hardware Description: 
① Top Heater ② Bottom Heater (Pre-Heater) ③ PCB Main Support ④ Smart Digital Control Bottom Heater ⑤ Smart Digital Control Top Heater ⑥ Highly Sensitive Thermocouple K ( Temperature Sensor ) ⑦ LED Auxiliary Lighting |
Recommendations (1) Install the machine in a fresh area with no air currents, avoid to install the machine close to air conditioning units, fans or other air flow devices. (2) Place the thermocouple of the BIRD ® ANY CHIP IR3000 Rework Station properly on top of the chip so the temperature can be accurate. (3) Use insulation tapes to avoid capacitators or other IC components damage due to the heat used in the BGA Chip. Also remove the tape when the work is done to avoid short-circuits. (4) After removal of BGA chip ，Clean your PCB and your chip pads with Tin Line to avoid the presence of cold solder, to avoid Pads Damage. (5) The alignment of a Chip in a board can be 80 % accurate in the contacts to be workable. (6) To improve success rate of Rework , Let the PCB and Chip dry, if not can cause burning and explosions of IC Components. (7) Do not over do your PCB or the board will decolorize and lose conductivity even can burn. (8) Use a preheating site properly to start loosen up and expand your board, then can increase as need it to match the top heater temperature and remove the chip easier. No work need more than 250 degrees in pop up a chip, and no need more than 300 for reflowing which also is applied very little time . Please do not over heat your boards. (9) Common setting of temperature 
(10) More tips on working with the machine in support#dragongroupchina.com (Change # into @ , we write # to avoid SPAM) This setting of temperature is based on common chips and is generic and does not include or make reference to specific chips or special metal plated ones or reinforced ones. | 
